ABB产品-电气行业

14 Set-up | Application manual: Waste water pump | 1SFC132104M0201 4.1 Navigation This chapter describes how to set-up the PSTX softstarter according to the recommendation for a waste water pump. For a complete list of settings and more details about how to set up the softstarter, please see The Installation and commissioning manual (1SFC132081M0201) available on http://new.abb.com/low-voltage/ products/softstarters . All parameters are available under Complete list in the Parameters menu. The set-up of a waste water pump is done in three steps. 1. The basic set-up to set rated current. language and time, see chapter 4.2 Basic Set-up and application Set-up 2. Application set-up to set up the softstarter for a centrifugal pump, see chapter 4.3 Application set-up 3. Recommende change of parameter values for a waste water pump, see chapter 4.4 Recommended change of parameter values Figure 15: Complete list navigation 08 Sequence start 08.01 Sequence mode 08.02 Ie seq 1 08.03 Start mode seq 1 05 Slow speed 05.03 Slow speed reverse 05.04 Slow speed rev strength 13 Protections 13.10 Locked rotor op 14 Protections 14.02 Curr underload trip time 14.05 Curr underload op 10 Internal 10.02 In1 function 10.03 In2 function 10.06 K6 function Complete list Favorites Modified MENU Parameters Assistants Motor jog Event log Backup handling System info Settings Complete list 01 Motor rated current Ie 02 Start and stop 03 Limit 04 Kick start 05 Slow speed 06 Motor heating 07 Motor braking 08 Sequence start 09 Automatic restart 10 Internal IO 11 External IO 12 Communication 13-19 Protections list 1-7 20-24 Warnings list 1-5 25 Internal faults 26 External faults 27 Presentation 28 Service 3 4 Set-up